Publicidad
Idiomas disponibles
Idiomas disponibles
EN
• Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
• Do not spray water onto the motor and electrical
components.
13.3
REMOVE EXCESS LINE
1.
Push the tabs (5) on the sides of the trimmer
head at the same time.
2.
Pull and remove the spool cover (1) and spool
(2).
3.
Remove any remaining line.
4.
Clean dirt and debris from all parts. Replace
spool if it is worn or damaged.
5.
Align the spool tabs (5) with the tab openings (4)
in the base of the spool (3).
5
4
6.
Push the spool cover until it clicks into position.
English
13.4
If any parts of the spool retainer assembly are
damaged or worn, replace the damaged part and
reassemble them as following showing
1.
Disassemble the trimmer head. Pull and remove
the spool cover (5).
2.
Clean dirt and debris from all parts.
3.
Loosen the screws (1). Remove the spool (2),
slot cover (3), location housing (4) from the spool
assembly.
4.
Replace with a new spool.
5.
Insert the location housing and slot cover onto the
spool cover, and then put the spool onto the slot
cover to the desired position.
6.
Tighten with the screws.
1
2
3
13.5
Do not put more than 18 feet of cutting line in at a
time.
1.
Remove the remaining cutting line on the spool.
2.
Line up the slots on the spool cover with the slots
(1) on the trimmer head.
14
REPLACE THE SPOOL
NOTE
1
2
3
INSTALL THE CUTTING LINE
NOTE
4
5
Publicidad
