Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
Possible
Cause
The ma-
The guard is
chine
not attached to
stops
the machine.
when you
Heavy cutting
are cut-
line is used.
ting.
The grass
winds around
the motor shaft
or the trimmer
head.
The motor is
overloaded.
The battery
pack or ma-
chine is too hot.
The battery
pack is discon-
nected from the
tool.
The battery
pack is deple-
ted.
English
Solution
Remove the battery
pack and attach the
guard to the machine.
Use only with the
nylon cutting line of
0.106" (2.7 mm) diam-
eter.
1. Stop the machine.
2. Remove the battery
pack.
3. Remove the grass
from the motor shaft
and trimmer head.
1. Remove the trim-
mer head from the
grass.
2. The motor will re-
cover to work as soon
as the load is re-
moved.
3. When you cut,
move the trimmer
head in and out of the
grass to be cut and
remove no more than
20 cm in pass.
1. Cool the battery
pack until its function
returns to normal.
2. Cool the machine
for approximately 10
minutes.
Install the battery
pack again.
Charge the battery
pack.
Problem
Possible
Cause
The line
Lines are wel-
does not
ded to them-
extend.
selves.
Not enough line
on the spool.
Lines are worn
and too short.
Lines are tan-
gled on the
spool.
The line
The machine is
keeps
used incorrectly.
breaking.
The grass
Cut tall grass at
winds
ground level.
around
the trim-
mer head
and motor
housing.
The line
The cut-off
does not
blade becomes
cut well.
dull.
Vibration
The line is worn
increases
down at one
obviously.
side and not ex-
tended in time.
17
LIMITED WARRANTY
BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period
of four (4) years against defects in materials, parts
or workmanship. Greenworks, at its own discretion
will repair or replace any and all parts found to be
defective, through normal use, free of charge to the
17
Solution
Lubricate with silicone
spray.
Install more line.
Extend the line.
1. Remove the lines
from the spool.
2. Wind the lines.
1. Cut with the tip of
the line, avoid stones,
walls and other hard
objects.
2. Advance the cutting
line regularly to keep
full cutting width.
1. Cut tall grass from
the top down.
2. Remove no more
than 20 cm in each
pass to prevent wrap-
ping.
Sharpen the cut-off
blade with a file or re-
place it.
Make sure that the
line on both sides is
equal. Extend the line.
GARANTIE OUTIL &
EN
Publicidad
