Publicidad
Idiomas disponibles
Idiomas disponibles
en
16
Changing the tool.
When there is danger of falling down, secure the machine using the provided
WARNING
safety strap; especially when working aloft, on vertical building elements or
overhead. In case of a power failure or when the mains plug is pulled, the magnetic holding
power is not maintained.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
Do not touch the sharp edges of the core drill bit. Danger of injury.
Tool holder (figure 6)
Loosen both screws of the tool holder using
the hex key.
Insert the pilot pin into the cutter.
Insert the cutter with the pilot pin into the
tool holder.
Tighten both screws of the tool holder onto
the flats on the cutting tool using the hex
key.
Fig. 6
Tool holder
5 mm
5.
Allen key
Centering pin
3.
1.
1.
5.
2.
4.
Core drill bit
Publicidad
