Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for core drilling.
Do not stop the drill motor during the drill-
ing procedure.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor
and carefully turn the carbide tipped cutter
out counterclockwise.
After each drilling operation, remove the
chips and the slug.
Error message/
Response of mag-
net button
Indicator lights up
green
Indicator flashes
green
Indicator lights up
red for 1 second
Indicator flashes
red 3 x
Indicator lights up
red continuously
Indicator flashes
red continuously
Meaning
Magnetic holding power is suf-
ficient.
Magnetic holding power possi-
bly insufficient.
– Motion sensor has actuated
– Overload shut-off has actu-
ated
– Incorrect mains voltage
– Magnet key actuated by mis-
take
No speed signal
– Incorrect mains voltage/mains
frequency
– Drill stand is overheated
– Button is blocked when
switching on
Power tool is defective.
Do not touch the chips with your bare
hand. Always use a chip hook.
Danger of burns! The surface of the
magnet can reach high temperatures.
Do not touch the magnet with your
bare hands.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, remove
the core and the chips after having drilled
through each layer.
Corrective action
Even when working on steel mate-
rials where the material thickness is
below 12 mm, the workpiece must
be made thicker with an additional
steel plate in order to ensure the
magnetic holding power.
After malfunction correction, the
power tool can be switched on
again.
If the error occurs frequently, send
the machine to your FEIN customer
service agent.
After malfunction correction, the
power tool can be switched on
again.
If the error occurs frequently, send
the machine to your FEIN customer
service agent.
Send the machine to your FEIN cus-
tomer service agent.
en
23
Publicidad
