SPIT 218 Lithium Manual Original página 22

English
22
Try to avoid causing the machine to jam. When this
happens, it requires an excessive amount of energy,
which means that the battery becomes discharged
sooner and is subject to higher wear.
If you notice that you have to charge the battery
more and more frequently, it is spent and must be
EN
replaced.
Observe the instructions for disposal.
Battery cap
A battery cap 5 is enclosed in the delivery to allow
you to protect the contacts of the battery when it
is removed.
Fit this cap 5 over the battery contacts when
storing, transporting or disposing of the battery.
If the battery cap is not fi tted, loose metal parts
could short-circuit the contacts, creating a danger
of fi re and explosion.
Battery charge level indicator
The three LEDs on the charge level indicator 3 show
the level of the charge in the battery.
Press the button IV to display the charging status.
The charge level indicator LED goes out automa-
tically after approx. 5 seconds.
If one of the LEDs fl ashes when the button IV is
pressed, the battery needs charging!
If none of the LEDs lights up when the button IV is
pressed, the battery is faulty and must be replaced.
While the battery is charging, the three LEDs light up
consecutively. The battery is fully charged when the
three LEDs all light up continuously at the same time.
The three LEDs go out again approximately fi ve
minutes after completion of the battery charging
process.
Battery-operated work surface lighting
The LED lighting 6 allows you to light the spot you
are working on when lighting conditions are poor.
 Press the lighting button V to switch it on.
 Press the button V again to switch the lighting
off.
-NOTE-
The work surface lighting is switched off while
the battery charge level is being displayed. The
lighting is automatically reactivated when the
charge level indicator LEDs go out.
Battery charger
Observe correct mains voltage!
Before putting the tool into operation, check that
the mains voltage and frequency on the type plate
match the details of your mains supply.
Mains cable charger
Fixed power supply
Fixed power supply
Damaged mains cables must not be used. They
must be replaced immediately by an expert tech-
nician.
Specifi ed conditions of use for the
charger
The charger is intended solely for charging SPIT
batteries. Ensure that you use the right batteries for
the charger, see "Appropriate batteries"..
Symbols
Battery fully charged
Battery is charging
Battery is fl at
Use SPIT batteries!
Operation of battery
Appropriate batteries
LI battery with a rated voltage
of 18.0 V DC.
Charging the battery
Only put original batteries into the
battery charger!
Spit 218 Lithium