Publicidad
8.1.2 Lift assembly with riser extension
Extension
1. Riser extension is set on the existing riser. The open side
faces inwards.
2. Set to the desired height (from 100 mm to 900 mm in
100 mm steps) depending on the ceiling height. Guide
the 4 hydraulic lines (fastened to the operating column)
upwards out of the riser.
3. Fasten the cover.
4. After setting up the lifting columns, lift the cross-con-
nection fastened to the operating column upwards
and fasten to the opposite side. The hydraulic lines
are placed in the cross-connection.
OPI-POWER LIFT HF 3S 3000-4000-V4.0-DE-EN-FR-ES-IT
5. Guide the lines from above into the riser of the oppo-
site side and connect to the colour marked positions.
6. Fasten the extension using the long screws after the
tensioning plate (A) has been placed.
Extension
A
8.1.3 Retrofitting the riser extension
Extension
1. The optional riser extensions are delivered in a box.
Have other supplied parts at hand: Hoses, covers,
plates, extensions, press panels, screws.
2. Riser extension is set on the existing riser. The open side
faces inwards.
Extension
103
Publicidad
