Publicidad
Version with Mini-Max lifting arms
Figure 1: Position carrier plate below the fixture points approved by the
vehicle manufacturer.
Figure 2: If required, place the carrier plate by pushing the lever at the
fixture points.
Ensure that the ratchet is securely locked
!
into the intended position. Otherwise the
„Mini-Max" can sink to its lowest position.
Figure 3: To release the fixture plate, the rear lever must be pushed.
• The lifting arm block must be ratcheted in after the fix-
ture point has been reached.
• After each set down of the vehicle, check the lifting arm
positions below the fixture points again and adjust as
required.
• Check that there are no people or objects in the hazard-
ous area of the lift.
OPI-POWER LIFT HF 3S 3000-4000-V4.0-DE-EN-FR-ES-IT
5.2 Lifting the vehicle
• Lift the vehicle until the wheels are off the ground. Push
the operating lever forwards v "Lift" (see figure 4).
• If the wheels are not blocked, interrupt the lifting process
and check for proper seating of the carrier plate. Simi-
larly check whether the lifting arm blocks are ratcheted
in. Otherwise, lower the lift and reposition the vehicle.
• After each set down of the vehicle, check the lifting arm
positions below the fixture points again and adjust as
required.
• Check that there are no people or objects in the hazard-
ous area of the lift.
• Afterwards, lift the vehicle to the desired working height.
Ensure secure vehicle placement on
the carrier plate, otherwise there is
a danger of the vehicle dropping.
See to it that the lifting arm blocks are ratcheted in after
i
the vehicle has been accepted.
Figure 4: Operating unit
Pushbutton "Set down in latch"
"CE-Stop" button
main switch
Operating lever
Fig. similar
93
Publicidad
