Publicidad
Idiomas disponibles
Idiomas disponibles
Greatest rated value for
welding time in intermittent
mode Σ
INVERTER FLUX CORED WIRE
WELDER PIFDS 120 A1
z Introduction
Congratulations! You have
purchased one of our
high-quality devices. Please
familiarise yourself with the product before
using it for the first time. To do so, please
read through the following operating and
safety instructions carefully. This tool must be
set up or used only by people who have
been trained to do so.
KEEP OUT OF THE REACH OF
CHILDREN!
z Intended use
The device is suitable for self-shielded flux
cored wire welding using an appropriate
wire. No additional gas is required. The
shielding gas is contained in powder form in
the wire itself, thus it is fed directly into the
arc. This means the device is not susceptible
to wind and can be used outside. Only
suitable wire electrodes may be used for
the device. Observing the safety instructions
and assembly instructions and operating
information in the instructions for use is also
a component of the intended use.
It is imperative to adhere to the applicable
accident prevention regulations. The device
must not be used:
– in rooms with insufficient ventilation,
– in explosive atmospheres,
– for the purpose of thawing pipes,
– in the vicinity of people with cardiac
pacemakers and
t
ON
Greatest rated value for
welding time in continuous
mode Σ
– in the vicinity of easily inflammable materi-
als. Use the product only as described and
only for the specific applications as stated.
Keep these instructions in a safe place.
Ensure you hand over all documentation
when passing the product on to anyone
else. Any use that differs to the intended
use as stated above is prohibited and
potentially dangerous. Damage or injury
caused by misuse or disregarding the
above warning is not covered by the
warranty or any liability on the part of the
manufacturer.
Commercial use will void the guarantee.
z Package contents
1 inverter flux cored wire welder
PIFDS 120 A1
1 burner nozzle (pre-mounted)
4 welding nozzles (1x 0.9 mm pre-mounted;
1x 0.8 mm; 1x 0.6 mm; 1x 1.0 mm)
1 chipping hammer with wire brush
1 flux cored wire Ø 0.9 mm / 450 g
1 welding protection shield
1 carry strap
1 set of operating instructions
Residual risk
Even if you operate the device as intended,
there will be residual risks. The following
risks can occur in the context of the design
and construction of this inverter flux cored
wire welder:
– eye injuries caused by glare,
– touching hot parts of the device or the
workpiece (burn injuries),
– in the case of insufficient protection, risk of
accidents and burns due to flying sparks
or slag,
t
ON (max)
73
GB/MT
Publicidad
