Bosch SCT 815 S3 Manual Original página 7

1
2
3
(1) Laser range finder
(2) Horizontal shelf
(3) Positioning foot
7. Use the positioning foot
based on the inclination angle indicator of the laser
range finder.
 WARNING – severe eye damage from laser beam.
8. Never look directly into the laser source.
9. To test function, hold an object in front of the exit
point of the laser range finder.
10. Switch on the laser range finder.
11. Adjust the height of the prismatic reflector in such a
way that the laser point marks the center of the
bumper.
 The laser range finder indicates the current dis‐
tance between SCT 815 S3 and the bumper.
The laser range finder measures distance contin‐
uously. If the position of SCT 815 S3 changes, the
new distance from the bumper will be shown on
the display of the laser range finder.
12. Make sure the back of the laser range finder touches
the rear stop of the horizontal shelf.
2
1
3
(1) Laser range finder
(2) Rear stop of horizontal shelf
(3) Mount for laser range finder
If the back of the laser range finder does not
touch the rear stop of the horizontal shelf, there
will be observational errors.
13. Use the laser range finder to position SCT 815 S3 at
the precise specified distance from the front of the
vehicle.
 The position of SCT 815 S3 is correct when the
laser range finder reading matches the specifica‐
tion from the brief instructions.
---
Robert Bosch GmbH
(3)
to level SCT 815 S3
4.4 Aligning SCT 815 S3 with the vehi‐
cle's longitudinal center plane
(1)
1. Attach the line laser
ser (4), and use the retaining cable to secure it.
2. Use the positioning feet
accordance with the spirit level on the mount for the
line laser (2).
1 1
2 2
(1) Line laser
(2) Spirit level on line laser mount
(3) Positioning feet
(4) Retaining cable
 WARNING – severe eye damage from laser beam.
3. Never look directly into the laser source.
4. To test function, hold an object in front of the line
laser exit point.
5. Switch on the line laser.
 The laser line now runs across the vehicle.
6. Align SCT 815 S3 in such a way that the laser line
(2)
runs across the manufacturer badge on the front
of the vehicle and the antenna.
1
3
2
(1) Line laser
(2) Projected laser line
(3) Manufacturer badge
(4) Antenna
Depending on the vehicle, other fixed points can
be used to align SCT 815 S3 with the vehicle's
longitudinal center plane using the line laser.
---Separator---
SCT 815 S3 | 7 | en
to the mount for the line la‐
(3)
to level SCT 815 S3 in
4
3 3
4
1 689 989 477 | 2020-05-01