Publicidad
Idiomas disponibles
Idiomas disponibles
1
(1) Knurled screw
12. Use the laser range finder to position the prismatic
reflector at the precise specified vehicle-specific
height.
— If the vehicle rests on a lift or leveling surface,
measure the difference in height and add it to the
vehicle-specific height.
13. Use the knurled screw to secure the tool holder.
---
4.5.2
Adjusting the height of the prismatic reflector
using the manufacturer's badge or the front
radar sensor
The height of the prismatic reflector is specified in the
corresponding brief instructions. The height specific to
the vehicle is found in the column with the following
pictogram.
---
On some vehicles, the height of the prismatic re‐
flector depends on the position of the manufac‐
turer's badge or the front radar sensor. For those
vehicles, the height specification column states
where the red laser point must be positioned rel‐
ative to the manufacturer's badge or front radar
sensor.
---
1. Use the corresponding brief instructions.
2. Determine whether the height of the prismatic re‐
flector depends on the position of the manufactur‐
er's badge or front radar sensor.
3. Position the mount for the laser range finder
the prismatic reflector (2).
Robert Bosch GmbH
1
2
(1) Mount for laser range finder
(2) Prismatic reflector
4. Make sure the edges of the prismatic reflector
are aligned with the centers of the notches
mount for the laser range finder.
1
2
(1) Edges of prismatic reflector
(2) Notches in mount for laser range finder
Should the edges of the prismatic reflector be
misaligned with the centers of the notches, the
mount for the laser ranger finder will be inaccur‐
ately positioned. As a consequence, SCT 815 S3
cannot be correctly aligned.
5. Insert the laser range finder
shelf (2).
1
2
3
(1)
on
(1) Laser range finder
(2) Horizontal shelf
(3) Positioning foot
6. Use the positioning foot (3) to level SCT 815 S3
based on the inclination angle indicator
range finder.
SCT 815 S3 | 9 | en
1
(1)
(2)
in the
1
2
4712008-10_shd
(1)
into the horizontal
of the
laser
1 689 989 477 | 2020-05-01
Publicidad
