Bosch SCT 815 S3 Manual Original página 8

en | 8 | SCT 815 S3
4.5 Adjusting the height of the prismatic
reflector
4.5.1 ---Separator--- Adjusting the height of the prismatic reflector
according to the millimeter
The height of the prismatic reflector is specified in the
corresponding brief instructions. The height specific to
the vehicle is found in the column with the following
pictogram.
The vehicle-specific height from the brief instruc‐
tions applies if the vehicle rests on the same sur‐
face as SCT 815 S3. If the vehicle rests on a lift
or leveling surface, the difference in height must
be measured. The measured height must be add‐
ed to the vehicle-specific height from the brief in‐
structions.
1. Use the corresponding brief instructions.
2. Look up the height of the prismatic reflector for the
relevant vehicle.
3. Position the mount for the laser range finder
the prismatic reflector (2).
1
2
(1) Mount for laser range finder
(2) Prismatic reflector
4. Make sure the edges of the prismatic reflector
are aligned with the centers of the notches
mount for the laser range finder.
1 689 989 477 | 2020-05-01
(1)
on
1
(1)
(2)
in the
1
2
(1) Edges of prismatic reflector
(2) Notches in mount for laser range finder
Should the edges of the prismatic reflector be
misaligned with the centers of the notches, the
mount for the laser ranger finder will be inaccur‐
ately positioned. As a consequence, SCT 815 S3
cannot be correctly aligned.
5. Insert the laser range finder
shelf (2).
1
2
3
(1) Laser range finder
(2) Vertical shelf
(3) Positioning foot
6. Use the positioning foot (3) to level SCT 815 S3
based on the inclination angle indicator
range finder.
 WARNING – severe eye damage from laser beam.
7. Never look directly into the laser source.
8. To test function, hold an object in front of the exit
point of the laser range finder.
9. Switch on the laser range finder.
 The laser range finder indicates the current dis‐
tance between the prismatic reflector and the
ground.
 CAUTION – risk of crushing when adjusting the
height of the prismatic reflector.
10. Do not place fingers between the tool holder and
the guide tubes.
11. Loosen the knurled screw
til the height of the prismatic reflector can be adjus‐
ted.
1
2
4712008-10_shd
(1)
into the vertical
of the
laser
(1)
on the tool holder un‐
Robert Bosch GmbH