Joie bold R Manual De Instrucciones página 14

GROUP 1 (9-18kg) &
GROUP 2 (15-25kg)
With Isosafe system + 3-point-belt + top tether +
harness buckle
see images -
26 30
1. Press the webbing adjustment
the shoulder harnesses to the proper length.
2. Press the red button to disengage the buckle.
3. Make sure that both Isosafe connectors are securely
attached to their ISOFIX anchor points. The colors of the
indicators on both Isosafe connectors should be completely
green. -1
30
4. The booster can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the booster
securely. -2& -3
30 30
5. Make sure that tether hook are securely attached to the
anchorage fitting. The colors of the indicators on tether
strap adjuster should be completely green.
6. To ensure the correct head support height is obtained,
the bottom of the headrest MUST be even with the top of
child's shoulders as shown in
7. Pull down the adjustment webbing and adjust it to the
proper length so that your child is snugly secured. Make
sure the space between the child and the shoulder harness
is about the thickness of one hand.
13
button, while pulling out
26
27
-4
30
-5.
30
-6
30
GROUP 2 (15-25kg) &
GROUP 3 (22-36kg)
With Isosafe system + 3-point-belt
With Isosafe system + 3-point-belt + top tether
see images -
31 40
!
Store the shoulder strap cover, crotch belt cover, buckle
and harness straps in a safe place.
For installation with Isosafe system + 3-point-belt
1. Make sure that both Isosafe connectors are securely
attached to their ISOFIX anchor points. The colors of the
indicators on both Isosafe connectors should be completely
green. -1
37
2. The booster can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the booster
securely. -2& -3
37 37
3. Position shoulder belt through the shoulder belt guide
shown in -4.
37
4. It is very important to ensure that any lap strap is worn low
down, so that the pelvis is firmly engaged. The booster is
shown as .
37
14