Publicidad
Idiomas disponibles
Idiomas disponibles
Gas connection
with Type E adapter
If a rubber hose is being used,
please install the appropriate
adapter (see image above) directly
on the main gas pipe without any
adapters in between.
LEAK TEST
•
Perform the leak test each time the gas cylinder is connected or reconnected.
•
Never use an open flame to check for gas leaks.
•
Never smoke while performing the leak test.
•
Always perform the leak test outdoors, in a well-ventilated area, and away
from sources of ignition such as gasoline, open flames, sparks, or electrical
equipment.
•
The device must be checked regularly for gas leaks. If a smell of gas is
noticeable, the leak test must be carried out immediately.
Carrying out the leak test
•
Make a soapy solution of soap and water in a 1:3 ratio. The soap solution
can be applied with a bottle, brush, dish soap bottle or cloth to the areas to
be tested: gas cylinder valve, pressure regulator, all gas connections, hose
connections and along the entire length of the connection hose.
•
The gas valve must be turned to the "OFF" position when applying the soap
solution. Once the soapy solution has been applied all over, turn on the gas
valve to the "ON" position.
•
If there is a leak at one point, soap bubbles will appear at the corresponding
point.
•
If there is a leak, close the gas valve immediately. Tighten the leaking
connectors, open the gas valve and recheck all points.
•
If the leak does not stop after several attempts, contact your local gas dealer
or similarly qualified person. Do not use the grill under any circumstances
while there is a leak!
Gas connection
(France)
When using the gas grill in France,
please ensure that the appropriate
adapter (see image above) is
connected to the main gas line.
EN
23
Publicidad
