Publicidad
Idiomas disponibles
Idiomas disponibles
Ducting Options
CFM reduction kit
If required o desired this hood is to be used only in
conjunction with CFM reduction kit model KIT0175561�
Consult your HVAC professional and local building codes for
specific requirements in your area�
Ducting version
The hood is equipped with a 6" (15�2 cm) round transition
for discharge of fumes to the outside�
Roof Venting
A
B
A. Roof cap
B. 6" (15.2 cm) round vent
Preparation
Do not cut a joist or stud unless absolutely necessary� If a
joist or stud must be cut, then a supporting frame must be
constructed�
Fittings material is provided to secure the hood to most types
of walls/ceilings�
However, a qualified technician must verify suitability of the
materials in accordance with the type of wall/ceiling�
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent�
Recommended installation height:
Hood installation height above cooktop is the users preference�
The lower the hood is above the cooktop, the more efficient
the capturing of cooking odors, grease and smoke�
Installation
Prepare location
•
It is recommended that the vent system be installed before
hood is installed�
•
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent�
•
Check your ceiling height and the hood height maximum
before you select your hood�
1
Disconnect power�
2
Determine which venting method to use: roof, wall, or
nonvented�
3
Select a flat surface for assembling the range hood�
Place covering over that surface�
6
Wall Venting
B
A
A. Wall cap
B. 6" (15.2 cm) round vent
Closely follow the instructions set out in this manual�
All responsability, for any eventual inconveniences, damages
or fires caused by not complying with the instructions in this
manual, is declined�
Ductless (Recirculating)
In cases where it should not
be possible to discharge
cooking fumes and vapour
to the outside�
Attach a charcoal filter and
the deflector on the duct
cover support bracket�
Fumes and vapours are
recycled through the top
grille by means of a duct
connected to the transition
and the transition mounted
on the deflector�
For this version only:
purchase the Ductless
Recirculating Kit�
Minimum Duct Size:
6" Round Pipe�
I CAUTION
Installation Heights
GAS cooktops
ELECTRIC cooktops
There is no maximum mounting height, however, we
recommend mounting the hood no greater than 36" (91�4
cm) above the cooking surface� For every inch (2�54 cm)
above 36" (91�4 cm), fume and moisture capture efficiency
diminishes at an increasing rate and may not deliver an
acceptable level of ventilating performance�
This hood is intended for household use�
PLEASE READ THE INSTALLATION MANUAL FOR SPECIFIC
APPLICATION� Check your ceiling height and hood height
before selecting your hood�
I WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING�
4
Using 2 or more people, lift range hood onto covered
surface�
Mounting the duct cover bracket
1
Determine and mark the centerline on the wall where the
canopy hood will be installed� Disconnect power�
2
Select a mounting height from the Installation Heights
chart� Mark a reference line on the wall�
3
Tape template in place, aligning the template centerline
and bottom of template with hood bottom line and with
the centerline marked on the wall�
A
B
A. Deflector
B. 6" (15.2 cm) round vent
30" (76�2 cm)
24" (61 cm)
Publicidad
