Publicidad
Idiomas disponibles
Idiomas disponibles
EN
30
• When the burner is lit, adjacent burners are also lit as soon as the grill switch is
turned to "HIGH".
• At the "HIGH" setting, the burner flame should be about 12-20 mm long and the
orange flame portion should be minimal.
• Turn the gas control knob fully counter-clockwise for the minimum setting.
• If you have difficulty lighting the barbecue when following the above steps, contact
customer service or your local gas dealer.
• If the automatic ignition cannot be used, please remove the grill grate and heat
distributor (hot plate) and turn the switch counter-clockwise to 90° to ignite the
appliance with a barbecue lighter placed 5 mm from the burner hole.
• Then put the heat distributor and the grill grid back into the grill wearing protective
gloves and fire- and heat-resistant protective gloves.
Note: If the burner still will not light, turn the gas control knob to the "Off" position
and wait two minutes to allow the excess gas to dissipate before trying to light the
grill again.
Publicidad
