Publicidad
Idiomas disponibles
Idiomas disponibles
EN
24
LEAK TEST
• Perform the leak test each time the gas cylinder is connected or reconnected.
• Never use an open flame to check for gas leaks.
• Never smoke while performing the leak test.
• Always perform the leak test outdoors, in a well-ventilated area, and away from
sources of ignition such as gasoline, open flames, sparks, or electrical equipment.
• The device must be checked regularly for gas leaks. If a smell of gas is noticeable,
the leak test must be carried out immediately.
Carrying Out the Leak Test
• Make a soapy solution of soap and water in a 1:3 ratio. The soap solution can be
applied with a bottle, brush, dish soap bottle or cloth to the areas to be tested: gas
cylinder valve, pressure regulator, all gas connections, hose connections and along
the entire length of the connection hose.
• The gas valve must be turned to the "OFF" position when applying the soap solution.
Once the soapy solution has been applied all over, turn on the gas valve to the
"ON" position.
• If there is a leak at one point, soap bubbles will appear at the corresponding point.
• If there is a leak, close the gas valve immediately. Tighten the leaking connectors,
open the gas valve and recheck all points.
• If the leak does not stop after several attempts, contact your local gas dealer or
similarly qualified person. Do not use the grill under any circumstances while there
is a leak!
Publicidad
