Klarstein TOMAHAWK Manual De Instrucciones página 38

EN
38
Gas supply problems:
Attempting to light the
wrong burner.
The burner is not
connected to the control
valve.
The igniter is being
The burner is blocked.
used but the burner
does not light.
No gas flow.
Gas lock on the gas
cylinder connection nut.
The igniter is being
used but the burner
does not light.
The connection nut is not
properly connected to the
gas cylinder valve.
See the notes in the
"Commissioning and
Operation" section.
Make sure the valves are
inside the burner tubes.
Make sure the burner tubes
are not blocked by cobwebs
or similar.
Make sure the gas bottle is
not empty. If there is still gas in
the gas cylinder, see sub-item
"Sudden drop in gas flow".
Turn off all switches and
disconnect the connection nut
from the gas cylinder. Then
plug them back in and try
again.
Turn the connection nut
approximately half to three-
quarters of a turn.