GreenWorks 2101602 Manual Del Operador página 9

EN
4. Tighten the auxiliary handle with the knob (3).
8.5 INSTALL THE BATTERY PACK
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read and understand the instructions in the battery and
charger manual.
1. Align the lift ribs （3） on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
2
8.6 REMOVE THE BATTERY PACK
1. Push and hold the battery release button (1).
2. Remove the battery pack from the machine.
9 OPERATION
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
Be careful when you operate the machine.
9.1 START THE MACHINE
1. Push the lock-out button (1) and pull the trigger (2). Once
the machine is running you can release the lock-out
button.
WARNING
1
3
IMPORTANT
WARNING
English
1
9.2 STOP THE MACHINE
1. Release the trigger to stop the machine.
9.3 ADJUST THE LENGTH OF THE
CUTTING LINE
The machine has an auto-feed head. If the cutting line does
not automatically advance, it can be tangled or empty.
1. Start the machine and keep 3s. Release the trigger until
the machine totally stops.
2. Repeat the above step until you can hear the line-cutting
noise.
The line will extend approximately 0.4 in. with each stop
and start of the switch trigger until the line reaches the cut-
off blade and the cut-off blade cuts the excess length.
Do not pull or release the trigger too fast.
It will damage the machine if you hit the head to try to
advance the line.
9.4 ADJUST THE LENGTH OF THE
CUTTING LINE MANUALLY
1. Stop the machine. Remove the battery from the unit.
2. Push the spool retainer button (1) and pull on cutting line
to manually advance the cutting line.
3. After you extend new cutter line, always return the
machine to its normal position before you start it again.
8
2
NOTE
NOTE
NOTE
NOTE
1