Rapid BTX553 Manual Del Usuario página 8

a) Have your power tool serviced
by a qualifi ed repair person
using only identical replace-
ment parts. This will ensure that
the safety of the power tool is
maintained.
b) Never service damaged bat-
tery packs. Service of battery
packs should only be performed
by the manufacturer or author-
ized service providers.
TACKER SAFETY WARNINGS
• Always assume that the tool
contains fasteners. Careless
handling of the tacker can result
in unexpected fi ring of fasteners
and personal injury.
• Do not point the tool towards
yourself or anyone nearby. Un-
expected triggering will dischar-
ge the fastener causing an injury.
• Do not actuate the tool un-
less the tool is placed fi rmly
against the work piece. If the
tool is not in contact with the
work piece, the fastener may be
defl ected away from your target.
• Disconnect the tool from the
power source when the fas-
tener jams in the tool. While
removing a jammed fastener,
the tacker may be accidentally
activated if it is plugged in.
• Use caution while removing a
jammed fastener. The mecha-
nism may be under compression
and the fastener may be force-
fully discharged while attempting
to free a jammed condition.
• Do not use this tacker for
fastening electrical cables. It is
8
not designed for electric cable
installation and may damage
the insulation of electric cables
thereby causing electric shock
or fi re hazards.
TECHNICAL SPECIFICATION
Battery Tacker, model number
Staple type
Staple length
Magazine capacity staple, max
Brad nail type
Brad nail length
Magazine capacity nails, max
Weight (bare tool)
Dimensions H x W x L (bare tool)
Voltage
Recommended Battery capacity
(Bosch) POWER FOR ALL ALLIANCE: 18V Li-ion
Battery type
Recommended charger type (Bosch) POWER FOR ALL ALLIANCE: AL 18V-20
Stapling speed, max continuous
Battery information
Battery capacity
1.5 Ah
2.5 Ah
4.0 Ah
NOISE EMISSION/VIBRATION
• A-weighted sound pressure level LpA= 83.5
dB(A), uncertainty K=3 dB(A). A-weighted sound
power level LwA= 94.5 dB(A), uncertainty K=3
dB(A). Recommendation for the operator to wear
hearing protection.
• Vibration total value =3.3 m/s², uncertainty K=1.5
m/s². The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one tool
with another. The declared vibration total value
may also be used in a preliminary assessment of
exposure.
! WARNING
The vibration emission during actual use of
the power tool can differ from the declared
total value depending on the ways in which the tool
is used. It's needed to identify safety measures to
protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
DEFINITIONS
(Figure 1 - 4)
Trigger
BTX553 BTX606
Rapid 53 Rapid 606
8 - 20 mm 12 - 25 mm
156 pcs 100 pcs
Rapid T8 Rapid T8
15 - 20 mm 15 - 30 mm
100 pcs 100 pcs
2160 g 2120 g
264 x 71 x 240 (mm)
18 V
2.5 Ah
(Fig. 5)
20 shots/minute
Approx. shots per full charge, max
1500
2500
4000