Descargar Imprimir esta página

Whirlpool AFO ED4DS Instrucciones Para La Instalación página 11

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

1.4 WARNINGS FOR THE INSTALLER
Read carefully all the instructions in this manual, because they give important suggestions about the right instal-
lation, use and maintenance of the appliance.
1.4B CONTROLS AT RECEPTION
The appliance are shipped in appropriate protective packing. On arrival, check that the appliance has not incurred
in transport damage and that it iscomplete according to the order.
In the event of visible damage immediately note the damage on the transport documents with the following
wording:
RECEIVED WITH RESERVE FOR EVIDENT DAMAGE OF PACKING.
IMPORTANT:All the operations indicated below must be performed in respect of the existing safety regulations,
both for the equipment in use and for the operating procedures.
1.4C HANDLING
BEFORE BEGINNING HANDLING OPERATIONS ENSURE THAT THE LIFTING CAPACITY IS ENOUGH FOR THE AP-
PLIANCE IN QUESTION.
HANDLING with FORK LIFT or SIMILAR (A); Insert the forks into the side or back of the wooden pallet supplied
with the appliance, begin lifting checking that the appliance is in stable equilibrium. Attention: when insert the
lifting device, pay attention to the power supply cable and the position of the feet.
DURING HANDLING DO NOT TIP OR TURN OVER.
THE RESPECT OF THE RECOMMENDATIONS PRINTED ON THE OUTSIDE OF THE PACKING (D) IS A GUARANTEE OF
A SOUND PHYSICAL AND OPERATING CONDITION OF THE APPLIANCE, ALL TO THE ADVANTAGE OF THE END-US-
ER. THEREFORE THE FOLLOWING IS RECOMMENDED: HANDLE WITH CARE, KEEP DRY, STACKING OF OTHER
OBJECTS ON THE APPLIANCE MUST BE ABSOLUTELY AVOIDED, STACKING OF OVEN IS PERMITTED, TAKING CARE
OF THE MAXIMAL QUANTITY REPORTED ON THE PACKAGING (D).
1.4D PLACING
Lift the appliance to separate it from the pallet (A). Remove the packing (B) and the protective film avoid using
abrasive brushes or other damaging materials for the appliance's surfaces (C). Check that the appliance is per-
fectly levelled (C). Regulate the adjustable feet if it is necessary.
If you have a composition oven + neutral element, place the oven's legs in the proper place created in the top of
the neutral element.Place the appliance away from heat sources and in a ventilated room. Never obstruct any air
inlet on the oven in order to not compromise its performance and safety when the equipment is operating .Place
the appliance in a site easy to join, so every type of maintenance, control and repair may be done easily.
1.5 GENERAL INDICATIONS ON THE PROTECTIVE PACKING
1.5B INDICATIONS ON THE PROTECTIVE PACKING OF THE GAS OVEN
THIS APPLIANCE MUST BE CONNECTED FOLLOWING THE NORMATIVE
LAWS IN FORCE. THIS ITEM MUST BE USED IN A VENTILATED PLACE
GB
ONLY. BEFORE THE INSTALLATION AND THE USE OF THE APPLIANCE.
INSTRUCTIONS MUST BE READ DOWN CAREFULLY. THIS PACKAGING
HAS TO BE PROPERLY RECYCLED ACCORDING TO THE EXISTING LOCAL
REGULATIONS.
11
GAS
PREDISPOSED
CAT
G20
20 mbar
II2H3+
G30
28-30 mbar
G31
37 mbar
EN

Publicidad

loading