Whirlpool AFO ED4DS Instrucciones Para La Instalación página 17

4.0 PROBLEMS AND SOLUTIONS
THE OVEN DOES NOT SWITCH ON
• Check that all pole disconnection switch is switched on and that there is power (green light on)
• Set the timer
• Check if the safety thermostat has to be reset
• Check that the oven's door is closed
• Check the cooking session has been correctly set.
THE FAN SWITCHED OFF WHILE THE OVEN IS ON
Every 2 minutes the fan motor automatically reverses direction of rotation followed by a 20-seconds rest. If the
last cooking session ended with the fan rest period, the next time, you switch the oven on, the motor will remain
briefly switched off .
• Check that the fan is not temporarily switched off (no more than 20 seconds) due to the normal functioning of
the oven.
• Check that the oven's door is closed
• Check that the vet is not obstructed.
THE OVEN CHAMBER LIGHT DOES NOT WORK
• Use heat-resistant light bulbs
• Replace the light bulbs
HUMIDITY CONTROL TUBES ARE NOT DISCHARGING WATER
• Check that the water tap is open.
• Check that the filter is not obstructed
• Check that the humidity control has been switched on
WATER FILTER
If the water supply to the oven is interrupted , check the electrovalve input filter behind the oven:
• Turn off the water tap on the rising main
• Disconnect the tube connnecting the oven to the mains
• Use pliers to remove the filter located behind the electrovalve
• Clean filter of any impurities and replace it behind the electrovalve
• Reconnect the tube
RED LIGHT ALARM
Means that the burner is blocked. You have to press for 3 seconds the re-start button (see installation scheme).
5.0 ORDINARY MAINTENANCE
This section is dedicated to the end user and is important for the appliance to work correctly in the long term.
A few simple operations conscientiously carried out at set periods can avoid the need of servicing by specialised
personnel.
The operations to be made do not require any particular technical knowledge and can be summarised in simple
controls of the appliance components.
BEFORE BEGINNING ANY TYPE OF MAINTENANCE OR CLEANING WORK ON THE APPLIANCE DISCON-
NECT THE MAINS POWER SUPPLY (electric, water).
OVEN'S CLEANING
ATTENTION: BEFORE CLEANING THE OVEN YOU HAVE TO ENSURE THAT THE OVEN IS COLD.
At the end of the working day, clean the oven inside and out:
1. use only warm water and soap or a neutral detergent
2. rinse with plenty of water dry thoroughly
3. dry thoroughly
All food residuals and grease must be removed from the oven each time it is used for cooking; follow the 1-2-3
indications below.
Do not use abrasive materials and other products which could be damaging for the inox surfaces.
Use only alkali based products suitable for the purpose.
Do not use high pressure water jets to clean the oven.
If the oven does not work properly, switch the oven off, disconnect the electricity and water supply and notify
the technical assistance service.
For an extended period of non use we recommend to:
1. switch off the appliance by long pressing the (1) ON/OFF key
2. disconnect from all powers supply electric and water
3. leave the door ajar to avoid bad odors from forming
The appliance should be checked at least once a year by qualified and authorised personnel.
17
EN