Stihl HL-KM Manual De Instrucciones página 9

WARNING
If the vegetation being cut or the
surrounding ground is coated with a
chemical substance (such as an active
pesticide or herbicide), read and follow
the instructions and warnings that
accompanied the substance at issue.
WARNING
Inhalation of certain
dusts, especially organic
dusts such as mold or
pollen, can cause sus-
ceptible persons to have
an allergic or asthmatic
reaction.
Substantial or repeated inhalation of
dust and other airborne contaminants, in
particular those with a smaller particle
size, may cause respiratory or other
illnesses. Control dust at the source
where possible. Use good work
practices, such as operating the unit so
that the wind or operating process
directs any dust raised by the power tool
away from the operator. Follow the
recommendations of EPA / OSHA /
NIOSH and occupational and trade
associations with respect to dust
("particulate matter"). When the
inhalation of dust cannot be
substantially controlled, i.e., kept at or
near the ambient (background) level, the
operator and any bystanders should
wear a respirator approved by NIOSH /
MSHA for the type of dust encountered.
HL-KM
Operating Instructions
WARNING
Do not operate your power tool using the
starting throttle lock, as you do not have
control of the engine speed.
In the event of an emergency, switch off
the engine immediately – move the slide
control / stop switch / momentary stop
switch to 0 or STOP.
See section of your KombiEngine
instruction manual on the proper use of
the slide control / stop switch /
momentary stop switch.
WARNING
The cutting blades continue to move for
a short period after the throttle trigger is
released.
Accelerating the engine while the blades
are blocked increases the load and will
cause the clutch to slip continuously.
This may result in overheating and
damage to important components (e.g.
clutch, polymer housing components) –
which can then increase the risk of injury
from the blades moving while the engine
is idling.
WARNING
On units with an adjustable cutter bar:
Carefully adjust the cutter bar to the
desired cutting position.To reduce the
risk of injury, never touch the cutting
blades while making adjustments. Only
adjust the cutter bar when the blades are
no longer moving.
17ft (5m)
The power tool has a large range. In
order to reduce the risk of personal or
even fatal injury to bystanders from
falling objects or inadvertent contact with
the moving cutting blades of your power
tool always keep bystanders at least
17 feet (5 m) away when the power tool
is running.
DANGER
Your power tool is not
insulated against electric
shock. To reduce the risk
of electrocution, never
operate this power tool in
the vicinity of any wires or
cables (power, etc.)
which may be carrying
electric current.
Electricity can jump from one point to
another by means of arcing. Higher
voltage increases the distance electricity
can arc. Electricity can also move
through branches, especially if they are
wet. Maintain a clearance of at least
50 feet (15 m) between the pole pruner
(including any branches it is contacting)
and any electrical line carrying live
English
7