Fitting The Harness - Stihl HL-KM Manual De Instrucciones

English
1
Shut off the engine.
N
Fit the blade scabbard.
N
Pull back the sliding sleeve (1) and
N
use the lever (2) to swing the joint
upwards – in direction of drive tube
– until the cutter bar is flat against
the drive tube.
Release the sliding sleeve (1) and
N
make sure the lock pin engages the
quadrant (3).
14

Fitting the Harness

3
The type and style of the harness and
carabiner (spring hook) depend on the
2
market.
Shoulder Strap
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Full Harness
1
Put on the full harness (1).
N
2
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Close the locking plate (3).
N
Attaching Machine to Harness
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube –
hold the carrying ring steady.
1
3
2
2
1
1
2
HL-KM