Starting / Stopping The Engine - Stihl HL-KM Manual De Instrucciones

Disconnecting Machine from Harness
1
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Throwing Off the Machine
WARNING
The machine must be quickly thrown off
in the event of imminent danger.
Practice removing and putting down the
machine as you would in an emergency.
To avoid damage, do not throw the
machine to the ground when practicing.
Practice quickly detaching the power
tool from the carabiner as described
under "Disconnecting Machine from
Harness".
If you are using a shoulder strap:
Practice slipping the strap off your
shoulder.
If you are using a full harness: Practice
quickly opening the locking plate and
slipping the harness straps off your
shoulders.
HL-KM
Starting / Stopping the
Engine
Starting the Engine
1
Always follow the operating instructions
for the KombiEngine and basic power
2
tool.
Place the machine on the ground so
N
that it rests securely on the engine
support and the gearbox.
On models with an adjustable cutter
N
bar: Set the cutter bar to the straight
(0°) position.
Remove the blade scabbard.
N
To reduce the risk of accidents, check
that the cutting blades are not touching
the ground of any other obstacles.
If necessary, rest the gearbox on a
N
raised support (e.g. mound, brick or
something similar).
Make sure you have a firm footing,
N
either standing, stooping or
kneeling.
Hold the machine with you left hand
N
and press it down firmly – do not
touch the controls on the control
handle – see KombiEngine or basic
power tool instruction manual.
NOTICE
Do not stand or kneel on the drive tube.
WARNING
The cutting attachment may begin to
move as soon as the engine starts. For
this reason, blip the throttle after starting
– the engine returns to idling speed.
The starting procedure is now as
described in the instruction manual of
the KombiEngine or basic power tool
you are using.
Stopping the Engine
See KombiEngine or basic power
N
tool instruction manual.
English
15