HOW TO USE REMOTE CONTROLLER
Cooling/heating/fan only operation
Start
START/STOP button (
Press this button to start the air conditioner.
Mode select button (MODE)
Select Cool
, Heat
Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
Fan speed button (FAN)
Select one of
MED
, MED
• The
OPERATION lamp on the display panel
of the indoor unit goes on. And operation starts
after approximately 3 minutes. (If you select FAN
ONLY mode, the unit will start immediately.)
• The
: Fan only mode does not control
temperature.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
NOTE
When the indoor unit is operated together with
a cooling only outdoor model outdoor unit,
appears on the remote controller but the heating
operation is disabled.
17-EN
Carrier 1121250221.indb 17
Carrier 1121250221.indb 17
SWING
FAN
)
, or Fan only
.
)
LOW
, LOW
+
,
+
, HIGH
)
Dry operation
Start
SWING
START/STOP button (
Press this button to start the air conditioner.
Mode select button (MODE)
Select Dry
.
Temperature button (
Set the desired temperature.
• The fan speed display indicates
• The
OPERATION lamp on the display panel
of the indoor unit lights, and operation starts after
approximately 3 minutes.
.
Stop
START/STOP button (
Press this button again to stop the air conditioner.
– 17 –
Owner's Manual
FAN
)
)
.
)
9/26/22 11:15 AM
9/26/22 11:15 AM