Publicidad
Idiomas disponibles
Idiomas disponibles
Wireless remote controller A-B selection
To separate using of remote control for each indoor unit
in case of 2 air conditioners are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn
the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold
Control by the tip of the pencil. "00" will be
shown on the display. (Picture 1)
4. Press
on the display and "00" will disappear and the air
conditioner will turn OFF. The Remote Control B
is memorized. (Picture
Note:
1. Repeat above step to reset Remote Control
to be A.
2. Remote Control A has not "A" display.
3. Default setting of Remote Control from
factory is A.
23-EN
Carrier 1121250221.indb 23
Carrier 1121250221.indb 23
button on the Remote
during pushing
"B" will show
2
)
1
2
The FIX and SWING buttons will be disabled
when the air conditioner is not in operation
(including when the ON timer is set).
Do not operate the air conditioner for long hours
with the airflow direction set downward during the
cooling or dry operation.
Otherwise, condensation may occur on the
surface of the vertical airflow louver and cause
dew dripping.
Do not move the vertical airflow louver manually.
Always use the FIX button. If you move the
louver manually, it may malfunction during
operation.
If the louver malfunctions, stop the air conditioner
once, and restart.
When the air conditioner is started immediately
after it was stopped, the vertical airflow louver
might not move for 10 seconds or so.
Louver operation is limited when performing
g
o r
u
p
c
o
t n
o r
. l
s (
e
Adjust the horizontal airfl ow
Take hold of the lever on the horizontal airflow
louver and move them to adjust the airflow
direction as required.
You can adjust the airflow at the left, and right
locations of the louver.
– 23 –
Owner's Manual
CAUTION
e
p
a
g
e
1
) 5
9/26/22 11:15 AM
9/26/22 11:15 AM
Publicidad
