Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Before you clean the air conditioner, be sure to turn off the circuit breaker or main power switch.
Cleaning of indoor unit and remote controller
• Use a dry cloth to wipe the indoor unit and remote controller.
• A cloth dampened with cold water may be used on the indoor
unit if it is very dirty.
• Never use a damp cloth on the remote controller.
• Do not use a chemically-treated duster for wiping or leave
such materials on the unit for long. It may damage or fade the
surface of the unit.
• Do not use benzine, thinner, polishing powder, or similar
solvents for cleaning.
These may cause the plastic surface to crack or deform.
If you will not use the unit for at least 1 month
1. Operate the air conditioner in FAN ONLY mode for about half a
day to dry the inside of the unit.
2. Stop the air conditioner and turn off the main power switch.
3. Remove the batteries from the remote controller.
Check before operation
• Check that the air lters are installed.
• Check that the air outlet or inlet of the outdoor unit is not blocked.
Carrier 1121250221.indb 26
Carrier 1121250221.indb 26
WARNING
CAUTION
With
the MODE button
set to
FAN ONLY.
CAUTION
– 26 –
Owner's Manual
Wipe with dry cloth
Thinner
9/26/22 11:15 AM
9/26/22 11:15 AM
EN
26-EN
Publicidad
