Changing The Clamping Jaw Inserts (H); Daily Inspection; Lubrication Of Spindle Support - Rothenberger ROPOWER 50 R Instrucciones De Uso

6.3 Changing the clamping jaw inserts
 Turn the clamping chuck and open it until a screwdriver fits
inside.
 Undo the screws that secure the clamping jaw inserts (fig. 1).
 Place a thin rod onto the upper edge of the spring and pull
out the clamping chuck pin (fig. 2).
 Pull the clamping jaw insert forward (fig. 3).
 Insert a new clamping jaw insert and push it right to the back,
replace the spring and the clamping chuck pin. Tighten the
screw.
6.4

Daily inspection

Attention! Before starting the lubrication-works the power plug has to be
taken out of the power source.
 Check the mains plug, mains cable and extension cable to ensure they are undamaged.
 Correctly filled oil trough.
 Clean the oil tank if there are impurities in it.
 Inspect the dies, pipe cutter and internal deburrer for any wear and replace parts if there is
wear.
 Clean the clamping jaws with a wire brush if they are dirty.
 Check that the dowel screws are secure. Tighten if necessary.
 Remove dirt and chips from the machine regularly.
 Apply anti-rust grease if the machine is not going to be used for an extended period.
 The rear spindle support has to be lubricated periodically. The lubrication is only allowed for
persons which have been supervised in electrical safety issues.
6.5

Lubrication of spindle support

The rear spindle support has to be lubricated periodically.
1. Unscrew the motor cover mounting bolts and remove the motor cover from the machine.
2. The grease nipple located behind of the scroll (Fig. 52).
3. Use grease gun to pour grease (Fig. 53).
ENGLISH
(H)
27