Publicidad
Idiomas disponibles
Idiomas disponibles
Page 26
ENGLISH
NOTE On initial startup of a pool, it is best to shock using an alternate source, i.e., use a shock treatment available
at your local pool supplier.
Never use dry acid to adjust pH in arid geographic areas with excessive evaporation and minimal dilution of pool
water with fresh water. A buildup of by-products can damage the electrolytic cell.
The pH condition resulting from the operation of the saltwater chlorination system is close to neutral. However,
•
other factors usually cause the pH of the pool water to rise. Therefore, the pH in a pool chlorinated by a
saltwater system tends to stabilize at approximately 7.6. If the pool pH rises above 7.6 have a qualified service
representative test to see if other factors such as high calcium hardness or total alkalinity are the cause and then
balance accordingly.
•
Total Dissolved Solids (TDS) adding salt to pool water will raise the TDS level. While this does not adversely
affect the pool water chemistry or clarity, the pool water professional testing for TDS must be made aware salt has
been added for the sanitizing system. The individual performing the TDS test will then subtract the salinity level
to arrive at the correct TDS level.
•
New pool water in a recently filled or newly refinished pool may contain undesirable matter. This undesirable
matter could interfere with the saltwater chlorinator's ability to sanitize properly. Make sure the water is tested
by a qualified service representative and properly balanced before turning on the chlorinator system. New plaster
pools have a constant acid demand for six (6) months. Regular testing and correcting of the pH will reduce the
need for manual cleaning of the cell.
Sequestering Agents may be used in some areas where the total hardness of your source water may be unusually
•
high. High total hardness can contribute to scale formation in the pool. Sequestering agents will help keep
minerals in solution and under some conditions can prevent this from happening. Consult a qualified service
representative about the use of a sequestering agent.
4.5
Optimum Pool Water Conditions
In accordance with Association of Pool and Spa Professionals
water balance conditions be maintained on an on-going basis to protect the pool finish and equipment and ensure the
pleasing appearance of the water. The Nature
met.
Free Chlorine
Combined Chlorine (Chloramines)
pH
Chlorine Stabilizer (Cyanuric Acid)
Total Alkalinity
Calcium Hardness
Metals (Iron, Manganese)
Nitrates
Phosphates
4.6
Salt (NaCl Sodium Chloride)
4.6.1 When to Add Salt
Add salt to the pool if the salt is too low (see Table 1). For a new pool or newly resurfaced pool it is recommended to
wait at least 30 days (surface should be completely cured) before adding salt. Follow the pool surface manufacturer's
guidelines for your particular pool. For vinyl and fiberglass pools, salt can be added at start up.
|
Zodiac
Nature
2
Fusion soft
Installation and Operation Manual
®
®
CAUTION
(APSP) standards, we recommend the following
®
Fusion Soft is warranted to operate properly only if these conditions are
2
0.5 - 3.0 ppm. Continuous exposure to levels above 3.0 ppm may cause
corrosion of pool metals. Refer to Section 6.2 for Chlorine Testing
Procedure.
None (Super chlorinate to remove all chloramines.)
7.4 - 7.6 (Use muriatic acid to lower pH and soda ash to raise pH.)
10 - 50 ppm (For outdoor pools only.)
80 - 120 ppm.
175 - 400 ppm.
None.
None.
None.
Publicidad
