Hella Gutmann CSC-Kit Radar III Manual De Instrucciones página 37

Hella Gutmann
5. Remove the base support.
6. Start the calibration in the diagnostic device with
5.3. Adjusting the Rear Radar
5.3.1. Attaching the Wheel Clamp Modules to the Rear Wheels
Proceed as follows to attach the wheel alignment module to the rear wheel:
1. Attach one wheel alignment module on the left and right rear wheel respectively.
NOTICE
Pay attention that the level bubbles of both wheel clamp modules are centered.
CAUTION!
Laser radiation
Damage to/destruction of the retina
Never look directly into the laser beam.
2. Align the laser module vertically to the floor by turning it.
3. Switch on the laser module of the wheel clamp module.
The laser point is indicated on the even ground surface.
4. Perform the steps 2 and 3 for the second wheel alignment module.
Now both wheel alignment modules are correctly attached to the rear wheels.
5.3.2. Positioning the Base Support at the Right Distance and Parallel
Behind the Vehicle
Proceed as follows to position the base support of the Rear Cam Kit I Basic at the right distance and parallel behind the ve-
hicle:
1. Connect the diagnostic device to the vehicle (see mega macs user manual).
2. Select >Diagnostics< in the main menu.
3. Select the system to be calibrated under >Basic settings<.
CSC-Kit Radar III
.
Working with the Radar Kit III | 5.
37