Kichler 65 Imari Manual De Instrucciones página 17

SENSORLESS DC CONTROL PAIRING PROCEDURES
IMPORTANT: Ceiling fan blades MUST be installed before pairing procedure can begin.
Step 1. Program the wall control and/or the handset control separately. Once the following pairing is successfully done, both the
wall control and the handset control can be used for the fan.
For wall control, press the " " power button to turn off the wall control (the button will be up). Restore electricity to the ceiling
fan branch circuit at the circuit breaker or fuse box. Within 60 seconds of turning on the power, press the " " power button to turn
on the wall control (the button will be down), and then press the " " reverse button for 3 to 5 seconds. Light will blink twice. The
remote will now be programmed to your fan and ready for use.
For handset control, restore electricity to the ceiling fan branch circuit at the circuit breaker or fuse box. Within 60 seconds of
turning on the power, press " " power button for 3 to 5 seconds. Light will blink twice. The remote will now be programmed to
your fan and ready for use.
IMPORTANT: Do not interrupt the conditioning until the fan comes to a complete stop in approximately 5 minutes. All
functions of the control will be rejected during conditioning.
Step 2. Try different speed setting on both the wall control and the handset control to ensure the fan is now fully functional. If
programming is unsuccessful, retry the process starting from Step 1 again.
65" Imari | 17