Kichler 65 Imari Manual De Instrucciones página 9

INSTALLATION OF SAFETY CABLE
(required for Canadian installation ONLY)
A safety support cable is provided to help prevent the ceiling fan from falling,
please install it as follows.
Step 1. Attach the wood screw and washers to the ceiling joist next to the
mounting bracket but do not tighten. (Fig. 11)
Step 2. Adjust the length of the safety cable to reach the screw and washers by
pulling the extra cable through the cable clamp until the overall length is correct,
put the end of the cable back through the cable clamp, forming a loop at the end
of the cable. Tighten the cable clamp securely. Now, put the loop in the end of
the safety cable over the wood screw and under the washer. Tighten the wood
screw securely.
NOTE: Although the safety support cable is required for Canadian installations
only. It's a good idea to make the attachment with any installation.
Step 3. Insert the receiver into the ceiling mounting bracket with the flat side
of the receiver facing the ceiling. (Fig. 12) For best performance, make sure the
Black Antenna, on the end of the receiver, remains extended and not tangled
with any of the electrical wires.
Ceiling mounting
bracket
Attach safety cable
to ceiling joist with
screw and washer
Fig. 11
Receiver
Hanger
Bracket
Fig. 12
65" Imari | 9