Kichler 65 Imari Manual De Instrucciones página 7

HANGING THE FAN
(continued)
WARNING: All set screws must be checked, and retightened where
necessary, before installation.
Step 5. Remove the hanger ball from the downrod assembly by loosening
the set screw, unscrewing and removing the cross pin and unscrewing the
ball off the rod. (Fig. 7)
Step 6. Loosen the two set screws and remove the hitch pin and retaining
clip from the coupling on top of the motor assembly. (Fig. 8)
Step 7. Carefully feed the electrical lead wires from the fan up through the
downrod. Thread the downrod into the coupling until the Hitch pin holes
are aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws. (Fig. 8)
NOTE: This fan comes with a 6" downrod. please cut off the electrical lead
wires If you do not plan use a longer downrod.
Cross Pin
Hanger
Ball
Set Screw
Download
Fig. 7
Supply Wires
Downrod
Set Screws
Retaining Clip
Fig. 8
Set Screws
Hitch Pin
65" Imari | 7