Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE WALL CONTROL
SYSTEM WALL PLATE
CAUTION: MAKE SURE THE ELECTRICITY IS TURNED OFF AT THE
MAIN JUNCTION BOX OR THE CORRECT FUSE HAS BEEN PULLED
Outlet Box
OFF AT THE MAIN JUNCTION BOX BEFORE CONTINUING.
Switch
Wall Plate
WARNING: All wiring must be in accordance with the National Electrical
Screws
Code local electrical codes. Electrical installation should be performed by
Screws
a qualified licensed electrician.
Select a location to install the Wall Control System Transmitter and Wall Plate.
REMEMBER the control is not to be mounted outdoors. You can safely
use the transmitter outdoors but it should be mounted indoors away
from excess heat and away from contact with water or humidity.
Install the wall plate using an existing wall switch outlet box. Make sure the
electrical power is TURNED OFF at the main panel before continuing.
Fig. 21
If your ceiling outlet box has a ground wire (green or bare copper) connect
it to the ground wire from the wall switch and/or the ceiling mounting
bracket and push back inside the outlet box.
Install the wall plate on the existing wall outlet box using the screws
provided. (Fig. 21)
After installing the wall anchors, attach the wall plate with the mounting
screws to finish the installation.
18 | KICHLER.COM
Publicidad
