SMA SUNNY TRIPOWER 60-10 Instrucciones página 22

7 Installing the PSU Assembly
7 Installing the PSU Assembly
A
A
Figure 1 : Touchable areas
Position
A
-
Procedure:
1. Check that all PCB brackets are present and intact.
2. If the locking tab of a printed circuit board bracket is damaged, cut off the printed circuit
board bracket in question with electronic diagonal cutting pliers and remove it. In this process,
the assembly must not be damaged.
3. If any printed circuit board brackets are missing or have been cut off, insert the supplied
printed circuit board brackets in these positions.
4.
Damage to the assembly due to bending of the printed circuit board
If the assembly deflects too much during insertion, components on the assembly may be
damaged.
• Insert the assembly as described in the following step.
22 STP60-PSU-RM-xx-10
Designation
Area of the assembly that can be touched with-
out consequence. Area that can be used as a
holding point during mounting.
The remaining areas may not be touched. The
assembly can be damaged through touching.
NOTICE
SMA Solar Technology AG
A
Replacement Manual