Dexter 20VMPS2-85.1 Manual Del Usuario página 125

B. ADJUSTING THE CUTTING DEPTH
- Untight the depth adjustment lever.
- Manually push the lever at desired depth setting on the scale.
- Tight the depth Adjustment Lever at the desired setting.
VALIDATED CUTTING DEPTH (MM)
Wood
Aluminium
Polycarbonate plate
Tile
Galvanized steal sheet
WARNING: Always take in consideration the suggested blade depth setting.
C. CHANGING THE SAW BLADE
WARNING: To prevent personal injury, always remove the power source BEFORE assembling parts, making adjustments or changing
blades.
WARNING: Be sure to wear protective work gloves while handling the saw blade. The blade can injure unprotected hands.
WARNING: Only use saw blades that correspond with the characteristic data given in this manuel.
WARNING: This blade will be extremely hot after use. Be sure to let the saw blade and cool before changing blades.
MOUNTING
Clean the saw blade and all the clamping parts. Check the new blade. Place the blade onto the spindle with the label facing outward. The hole in the
blade should locate onto the spindle and fit firmly with the inner flange. Insert the outer flange over the spindle. Depress the spindle lock button.
Tighten the lock bolt with the hex key. Check that the blade is securely fastened by continuing to hold down the spindle lock button and attempting
to manually rotate the blade. If installed correctly, the blade should not spin.
WARNING: When mounting, ensure that the cutting direction of the teeth (direction of arrow on saw blade) is the same as the direction-
of-rotation arrow above the upper blade guard match.
WARNING: Use a saw blade suited to the material and cut quality desired.
REMOVING
Press the spindle lock button and keep it depressed. Place the hex key into the lock bolt. Turn the hex key clockwise to loosen the lock bolt. Remove
the outer flange. Grasp the blade with your gloved hand and remove the blade by the slot ofthe base plate.
WARNING: The spindle lock button may be actuated only when the saw blade is at a standstill.
D. SAWDUST EXTRACTION
Transportation of products can be operate with any kind of closed transport, the packaging of the manufacture or without it, but in this case, the
product must be prevented from mechanical damage, precipitation, exposure to chemically active substances and compliance with precautionary
measures for the transport of fragile goods.
E. TRANSPORTATION CONDITIONS
Your saw includes a vacuum adapter that attaches to the dust extraction outlet on the saw. This adapter port can be attached to a vacuum cleaner
(sold separately). The use of the vacuum is strongly recommended as it keeps the work area clean, strongly increases cut visibility and reduces
airborne dust. It also keeps dust out of the working elements of the guard.
27 mm
3 mm
16 mm
9 mm
0,6 mm
125
FR
ES
PT
IT
EL
PL
UA
RO
EN