Publicidad
Idiomas disponibles
Idiomas disponibles
instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
Bombas Comet/HPP-serie EL
INSTALLATION
The Garda Evo group must be installed rigidly on a planar frame (sized to prevent vibrations and buckling) with a
MAX tilt of 3°. Ensure sufficient space for the circulation of cooling air and to reach the lubrication points (oil levels,
grease nipples, etc.). Leave room to manoeuvre the selection levers. Secure to the frame before the most rigid part
(Garda Evo box) and then the pump installed in output. If necessary reposition the feet with the relevant spacers.
INSTALLATION HIGH PRESSURE PUMP
The high pressure pump is connected to the Garda Evo box through a bell (section below) and the two shafts are
connected by a flexible joint (Figure 5). The high pressure pump must be secured to the frame according to the
instructions in the "Instructions manual" (annexed). For the hydraulic system refer to the "Installation diagram"
shown in the manual.
Junta 4179-5020707024
page 110
40
Figure 5 Flexible coupling connection
35
Publicidad
