Publicidad
Idiomas disponibles
Idiomas disponibles
Instruction manual
for use and maintenance of the combined groups for the GARDA EVO series
oil top-up
oil level
Figure 6 Oil top-up/inspection (sheet parameters above)
GEARBOX LUBRICATION
The toothed wheels in the gearbox are lubricated from splashes. Ensure filling with the correct quantity of oil as
specified above. The high pressure pump and the vane pump are equipped with independent lubrication circuits.
Refer to the "Operating and maintenance manual" of each pump.
• First oil change between 100/200 hours and then every 300 hours (see above)
• Check oil level before using the combined group
• Maximum temperature of the oil of 95°C during operation
• For prolonged continuous use (within and no beyond the instructions in the "Operating manuals" for each pump)
it is recommended to install a Garda Evo box lubrication oil cooling system
START/USE/STOP
1. Connect the cardan shaft to the tractor PTO and to the splined shaft 1" 3/4 of the GARDA EVO group.
2. Select the desired output lever and start slowly until reaching the desired RPM
3. Output selection (A or B or A + B) must be made with the PTO stopped.
4. To finish the operations disconnect the PTO of the tractor.
page 111
Publicidad
