Bresser National Geographic 9070300 Manual De Instrucciones página 34

6.
7.
8.
9.
10 Automatic time setting
After the power has been restored, the unit automatically
searches for the radio signal. It takes approximately 3-8
minutes for this process to be completed.
If the radio signal is received correctly, the date and time
are set automatically and the reception symbol is displayed.
If no radio signal has been received, proceed as follows:
1.
2.
3.
11 Manual time setting
1.
2.
3.
4.
5.
34 / 80
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Push the CH button to set the desired transmission
channel (setting CH1, CH2 or CH3 on screen display).
Push the °C/°F button to set the desired temperature
format (setting °C or °F on screen display).
Replace the battery compartment cover.
Press the UP button for approx. 2 seconds to initiate
the reception of the radio signal again.
Press the UP button for approx. 2 seconds to initiate
the reception of the radio signal again.
If still no radio signal is received, the time must be set
manually.
Press and hold SET button for approx. 2 seconds to
change to time setting mode.
Digits to be set are flashing.
Press UP or DOWN button to change the value.
Press SET button to confirm and continue to the next
setting.
Settings order: Year > Month > Day > Time zone >
12/24-hour mode > Hours > Minutes