Publicidad
Idiomas disponibles
Idiomas disponibles
(1)
(2)
(3)
39-EN
1
In the "Field setting menu" screen, press
[
] and [
] to select "Test mode", and
then press [
Set/Fix]
Test mode is set, and returns to the "Field
setting menu" screen. Press the [
Return]
button 2 times, to open screen (2).
2
Press [
ON/OFF]
Operation starts, and in test mode screen (1)
opens. (While stopped, it is screen (2))
Test mode is done while the operating mode is
set to "Cool" or "Heat".
The temperature cannot be set in test mode.
Check codes are displayed in the normal way.
3
After completing test mode, in the "Field
setting menu" screen, press [
] and [
to select "Test mode", and then press
[
Set/Fix]
Screen (3) appears.
Press [
Set/Fix] to end test mode and do
normal operation.
Wireless remote controller
(RBC-AX33UYP-UL)
Test run (forced cooling operation)
REQUIREMENT
Finish the forced cooling operation in a short time
because it applies excessive strength to the air
conditioner.
How to perform forced cooling operation
1
When TEMPORARY button is pushed for
10 seconds or more, "Pi!" sound is heard
and the operation changes to a forced
cooling operation. After approx. 3 minutes,
a cooling operation starts forcedly.
Check cool air starts blowing. If the operation
does not start, check wiring again.
2
To stop a test operation, push TEMPORARY
button once again (approx. 1 second).
Check wiring / piping of the indoor and outdoor
units in forced cooling operation.
]
TEMPORARY
button
– 20 –
EN
FR
ES
40-EN
Publicidad
