Publicidad
Idiomas disponibles
Idiomas disponibles
Warning indications on the air conditioner unit
W
a
n r
n i
g
n i
d
c i
t a
o i
n
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect all remote
electric power supplies
before servicing.
WARNING
Moving parts.
Do not operate unit with grille
removed.
Stop the unit before the servicing.
CAUTION
High temperature parts.
You might get burned
when removing this panel.
CAUTION
Do not touch the aluminum
fins of the unit and ionizer PIN
of Air purifier.
Doing so may result in injury.
CAUTION
BURST HAZARD
Open the service valves before
the operation, otherwise there
might be the burst.
5-EN
D
e
s
c
i r
t p
o i
n
WARNING
ELECTRICAL SHOCK HAZARD
Disconnect all remote electric power supplies before servicing.
WARNING
Moving parts.
Do not operate unit with grille removed.
Stop the unit before the servicing.
CAUTION
High temperature parts.
You might get burned when removing this panel.
CAUTION
Do not touch the aluminium fins of the unit and ionizer PIN of
Air purifier.
Doing so may result in injury.
CAUTION
BURST HAZARD
Open the service valves before the operation, to avoid unnecessary
pressure built up which could lead to explosion.
– 3 –
1
Precautions for safety
The manufacturer shall not assume any liability for the damage
caused by not observing the description of this manual.
WARNING
General
Before starting to install the air conditioner, read through the
Installation Manual carefully, and follow its instructions to install
the air conditioner.
Only a qualified installer or service person is allowed to do
installation work. Inappropriate installation may result in water
leakage, electric shock or fire.
Do not use any refrigerant different from the one specified
for complement or replacement. Otherwise, abnormally high
pressure may be generated in the refrigeration cycle, which
may result in a failure or explosion of the product or an injury to
your body.
Before opening the air inlet grille of the indoor unit or service
panel of the outdoor unit, set the circuit breaker to the OFF
position. Failure to set the circuit breaker to the OFF position
may result in electric shocks through contact with the interior
parts. Only a qualified installer or qualified service person is
allowed to remove the air inlet grille of the indoor unit or service
panel of the outdoor unit and do the work required.
Before carrying out the installation, maintenance, repair or
removal work, set the circuit breaker to the OFF position.
Otherwise, electric shocks may result.
Place a "Work in progress" sign near the circuit breaker while
the installation, maintenance, repair or removal work is being
carried out. There is a danger of electric shocks if the circuit
breaker is set to ON by mistake.
6-EN
Publicidad
