GASPARDO MONICA 250 Empleo Y Mantenimiento página 59

3.8.2 ROW MARKER DISK ADJUSTMENT
Row marker with trace on the tractor wheel (L1)
Using the Table 6 shown, read the distance (L1 Fig. 36) at which
the disc is to draw the reference line. Regulate the disc at the
correct distance, tilt it slightly and firmly tighten the nuts (Fig. 39).
For distances not covered by the table, use the following rule:
L= D (N +1) - C
Row marker with trace in the centre of the tractor (L2)
Using the Table 6 shown, read the distance (L2 Fig. 39) at which
the disc is to draw the reference line. Regulate the disc at the
correct distance, tilt it slightly and firmly tighten the nuts (Fig. 40).
For distances not covered by the table, use the following rule:
The row marker arms have a safety bolt (A Fig. 40) so that the
planter unit structure will not be damaged. If they happen to bump
into an obstacle, this bolt will break and so the row marker arm
will rotate to leave the equipment structure intact. There are spare
bolts on the row marker arm support (B Fig. 40).
TRANSPORT ON ROAD
fig. 41
D
D
C
cod. G19502561
2
L= D (N +1)
2
E
USE AND MAINTENANCE
n° file
nr.rows
D
Reihen.
Nr. Rangs
nr. Hileras
45
50
6
70
75
fig. 39
fig. 40
g
L1
C
120 130 140 150 160 170
975 925 875 825 775 725
1150 1100 1050 1000 950 900
1850 1800 1750 1700 1650 1600 1550
2025 1975 1925 1875 1825 1775 1725
L1
45÷50 cm
L2 - OPTIONAL
45÷50 cm
ENGLISH
L2
180 190
675 625 1575
850 800 1750
2450
1500
1675 2625
Table 6
70÷75 cm
70÷75 cm
A
B
59