Publicidad
OPERATING INSTRUCTION
6.2
Check the application conditions:
en
10
O P E R A T I N G I N S T R U C T I O N | GSE2 Flat Side
Figure 2: Alignment GSE2F
Sensing range
Observe the application conditions: Adjust the distance between the sender and the
receiver according to the corresponding diagram [see
operating reserve).
If several through-beam photoelectric sensors which are installed next to one another
are to be used, we recommend swapping the sender/receiver arrangement at every
second through-beam photoelectric sensor and ensuring that there is sufficient dis‐
tance between the through-beam photoelectric sensors. By doing this, mutual interfer‐
ence can be prevented [see
Operating reserve
100
10
1
0
20
40
(0.79)
(1.57)
Distance in mm (inch)
Figure 3: Operating reserve 50 mm
figure
figure
1].
1
0
0
60
80
(2.36)
(3.15)
Sensing range
Figure 4: Sensing range 50 mm
3] (x = sensing range, y =
40
60
20
40
60
80
(0.79)
(1.57)
(2.36)
(3.15)
Distance in mm (inch)
Sensing range max.
8023329.1HTH/2023-03-02 | SICK
Subject to change without notice
Publicidad
