Publicidad
OPERATING INSTRUCTION
2
Safety information
en
2.1
Intended use
3
Product description
3.1
Operating and status indicators
6
O P E R A T I N G I N S T R U C T I O N | GSE2 Flat Side
NOTE
Highlights useful tips and recommendations as well as information for efficient and
trouble-free operation.
Instructions to action
The arrow denotes instructions to action.
b
1.
The sequence of instructions is numbered.
2.
Follow the order in which the numbered instructions are given.
✓
The tick denotes the results of an action.
Connection, mounting and configuration of the product must only be car‐
ried out by qualified personnel.
This product does not constitute a safety component as defined in the
NO
Machinery Directive.
2006/42/EC
SAFETY
Do not install the product in places exposed to direct UV radiation (sun‐
light) or other weather conditions.
The product must be adequately protected against moisture and contami‐
nation.
The GSE2F(S) is an opto-electronic through-beam photoelectric sensor (referred to as
"sensor" in the following) for the optical, non-contact detection of objects, animals, and
persons. A sender (GS) and a receiver (GE) are required for operation. If the product is
used for any other purpose or modified in any way, any warranty claim against SICK AG
shall become void.
1 2
Green LED: supply voltage active
1
Receiver: Yellow LED: status of received light beam
2
1
2
8023329.1HTH/2023-03-02 | SICK
Subject to change without notice
Publicidad
