Sagola Altair LED 4600 Xtreme Manual De Instrucciones página 17

16/17
High precision visual control in colours spray. Visual control of layer coverage and fan pattern
overlap, as well as correct orientation of metallic particle or pearl effect avoiding variations of
tone due to bad dispersion of particles and/or mottling due to lack or excess of paint supply.
Improvement of finish quality. As in the colour base, a better control of layer dispersion and fan
pattern overlap will be achieved avoiding irregular clear coat supply (lack or excess material),
gloss irregularities, load irregularity (orange peel).
It is intended for use in hazardous environments, such as explosive environments, where only
devices with appropriate hazardous certifications (such as "intrinsically safe" and/or "explosion-
proof") should be used.
08. Start up
Your Battery's First Charge Is Important!
To assure the freshness of your battery and to avoid any operational
problems in shipping, it has been packaged in an UNCHARGED state. For
optimum operation of your flashlight, it should be charged a full 4 hours
approx. before using for the first time.
The charging cradle is provided with an LED that indicates battery charge status by changing
color, as seen in the accompanying chart.
Battery state
0 – 98 %
98 – 100 %
1. Connect the USB charger to the mains with the two
batteries in the correct position.
2. The LED indicator on the charger should be red.
3.After the estimated charging time has elapsed, and
the LED indicator on the charger is green, disconnect
the charger. Your batteries are now charged.
The charger has overcurrent and short-circuit protection functions and reverse polarity protection.
After being fully charged, there is no need to power off immediately, and it will not be overloaded.
Charging method: constant current and constant voltage.
CHARGING CRADLE FUNCTIONS
Charger mode
Charging
Idle
ENGLISH
LED Indicator
Red
Green