Publicidad
Idiomas disponibles
Idiomas disponibles
Before use, the following should be performed in an uncontaminated
area.
Batteries Installation
The battery was shipped outside of the flashlight. Batteries were packed outside of lighting
equipment. After the batteries are charged, unscrew the switch cap from the body of the ALTAIR
LED and insert the batteries into the battery compartment. (Fig. 1).
The positive (+) end (this is the end with a button) goes into the barrel first.
Now tighten the switch cap and make sure that it makes good contact and the LEDs turn on.
(Fig. 2)
Switch Operation
The ALTAIR LED includes a new powerful lighting system with two different functions to choose
from.
The two available function Sets are shown in the below Function Sets Chart.
Lighting level
LEVEL 1 (1 Battery)
LEVEL 2 (2 Batteries)
That is why these functions are organized into two different function sets; so that you can
personalize your flashlight to suit your needs, configuring it for quickest access to the functions
that best match your preference.
Fig. 1
LIGHTING TABLE
Power
Medium
Maximum
Level 1
ENGLISH
Fig. 2
Duration
160 min.
80 min.
Level 2
Publicidad
