Publicidad
Idiomas disponibles
Idiomas disponibles
o
PeratInG the UnIt
A. Check the device before you bring the same into operation,
whether the voltage indicated on the device matches with the lo-
cal mains voltage. Then plug the power cord (R) into the socket.
B. Attach the handpiece holder (S) on the device, you can do this
either on the left or on the right side.
C. Remove the handpiece (U) from the protective foil and put it in
the holder provided on the device side (S).
DE
D. Filling the spray tank
• Remove the spray container (M), by holding it from both the
EN
sides and carefully pull out from the case.
• Rotate the screw (L) and fill the spray container (M) up to ap-
FR
prox. 1-2 cm below the rim with distilled water. Rotate the screw
(L) again and keep the filled container back in the case till it
IT
is locked. Ensure here that the couplings (N) are fixed in each
other.
ES
• To work as fast as possible with an optimal spray function, let
the device run for approx. 4 minutes with the following settings
PT
for constant spraying:
- Insert a cutter, polisher etc. (see „power supply/ switching and
PL
instrument change")
- Low speed level: 4000 - 8.000 rpm (see „speed setting")
- Spray intensity of 100 % in active mode (see „spray setting")
This approach should be carried out after each filling of the
spray container. It takes about approx. 90 seconds till the first
time water comes out from the nozzle.
• Always use distilled water or a special mixture of distilled water
and maximum 30 % alcohol. Ordinary tap water possibly
contains calcium and other soluble substances that could cause
damage to the water tank, pumps, hoses and seals.
• Never fill any warm or hot liquids into the water tank.
• Do not overfill the water tank
• Fill the water tank up to maximum 1-2 cm under the upper edge
of the water glass.
Kaitstud / Secured by https://mereneid.eu/
• Regularly clean the water tank from inside by rinsing it with
distilled water.
• Always make sure that no foreign bodies reach in the water
tank. These could block the water tank, water pump, hoses or the
nozzle. Liquids which contain tea tree oil or the similar substances
that can damage the pumps! By using such substances you may
lose any warranty claims!
Publicidad
