Publicidad
Idiomas disponibles
Idiomas disponibles
o
PeratInG the UnIt
E. Electrical connection and switching the device on
• The mains cable is permanently installed and equipped with
a flat Euro plug (R). Connect the device to the mains and
switch it on by pressing the button (A).
• After you have switched the device on, the display (F) shows
the last function parameters selected.
• The tank is illuminated blue.
• The device is now in the standby mode. It can now be
operated individually via the membrane keyboard.
• Insert the desired milling cutter, polisher etc. into the chuck
of the handpiece. The handpiece motor must never be
running (please adhere to the instructions in "Changing the
instrument").
Note: Except for the on/off button (A), the device
acknowledges each push of a button with an acoustic signal.
F. Setting the speed
• Take the handpiece from the holder (S), hold it tightly in the hand
(e.g. in the writing position or in the hand grip) and now by
pressing the button (D)
is adjusted as follows:
–
From 2.000 rpm to 10.000 rpm in steps of 500
–
From 10.000 rpm to 30.000 rpm in steps of 1.000
–
From 30.000 rpm to 40.000 rpm in steps of 2.000
Kaitstud / Secured by https://mereneid.eu/
choose the desired speed. The speed
• By pressing the button
same level.
• Continuous pressing of the buttons (D)
of the speed levels occur.
• The regulation of the speed is (rpm X 1000) shown in two-digit (F)
on the display. For example, if the speed of the cutter is desired
as 15 000 rpm, press the button (D)
display (F).
Caution: Please always make sure that you adhere to
the abrasive product recommendation (milling head diameter
– recommended speed) of the device.
G. Activating / deactivating the rotation
• Press the Start/Stop button (B)
the handpiece.
• The icon of the rotation and function indicator (4) on the
display indicates active operation.
• If you wish to switch the motor off temporarily, press the
(B) button again. During the standby mode, the icon
of the rotation and function indicator (4) on the display is
illuminated.
(E) the speed can be reduced at the
or (E)
quick run
till it is shown on the
to activate the rotation of
DE
EN
FR
IT
ES
PT
PL
Publicidad
