Publicidad
Idiomas disponibles
Idiomas disponibles
PRE-INSTALLATION
FINISH PREPARATION (continued)
1-1/4" (32 mm)
front
nut bar
fin fastener
©Bruno Independent Living Aids, Inc.
5. Join rails, if necessary.
6. Upper and lower rail sections should now be
Fig. 1
7. Secure joint brackets to upper
1-1/4" (32 mm)
8. On lower rail, install remaining screws
Fig. 2
9. Add nut bars (Fig. 3).
back
Fig. 3
10. Trim charge strip carrier.
Fig. 4
12
®
Position upper rail section onto lower rail
section. Wiggle the upper section
slightly to make it align properly with
lower section (Fig. 1).
If installation involves a folding rail,
feed charge harness through upper
rail section before joining rails.
flush and snug.
rail using two (2) self-drilling hex
head screws per bracket,
(i.e., etched lines on rail per Fig. 1).
NOTE: Screws should be located no
more than 2-3/4" (70 mm)
from the joint if the bracket is
installed correctly .
(from Step 2 of Joint Preparation on page 9)
in upper and lower brackets.
With rail on a flat surface, slide one (1) nut bar
for each rail bracket into lower rear slot of rail.
If joined rails, add one (1) additional nut bar.
NOTE: There will be one (1) nut bar per
rai bracket plus one (1) directly
over the rail joint .
Trim 2-1/2" (63.5 mm) shorter than total
rail length.
If installation involves a folding rail,
insert fin fastener (Fig. 4) into the
mid-rail charge strip carrier at the joint.
Trim 1.5" (38 mm) shorter than total
rail length.
SRE-3000 INSTALLATION 02-08-2019
Publicidad
