Descargar Imprimir esta página

Bruno SRE-3000 ELAN Manual De Instalación página 41

Ocultar thumbs Ver también para SRE-3000 ELAN:

Publicidad

Idiomas disponibles

Idiomas disponibles

UNIT DOES
NOT OPERATE/
IS NOT CHARGING
UNIT OPERATES
SLOWLY, LACKS POWER
REMOTE CALL/SENDS
OPERATE BACKWARDS;
UNIT GOES UP SLOWLY
AND DOWN FASTER
UNIT OPERATES
ERRATICALLY OR
INTERMITTENTLY WITH
REMOTE CALL/SEND
UNIT OPERATES
ERRATICALLY OR
INTERMITTENTLY WITH
A RIDER USING ARMREST
MOUNTED CONTROL
SWITCH
UNIT WILL NOT
OPERATE UNLESS SEAT IS
POSITIONED SO IT FACES
OPEN SIDE OF STAIRS
UNIT WILL NOT OPERATE
WITH CALL/SEND
REMOTE
UNIT DOES NOT SHUT OFF
WHEN IT HITS BUMPER AT
END OF RAIL
ROUGH OR
CHATTERING RIDE
SRE-3000 INSTALLATION 02-08-2019
Check circuit breaker. Reset if necessary.
Check battery connections.
Check footrest safety switches to see if one of
these limit switches is depressed. Sliding safety
tray below footrest should slide freely and should
not stick in a position which would depress one of
the safety switches.
Check for discharged batteries. Battery voltage
should fall within the range of 16-28 VDC.
Check that keyswitch is ON.
Check for discharged batteries.
Check for loose connections.
Check that charger is plugged in and working.
Unit has been installed on right-hand side of stairs
and dip switch has not been set to right-hand and/
or seat has not been installed (circuit board).
Check all safety mechanisms, including swivel seat
safety switch.
Reorient transmitter to point directly at carriage.
Consult your dealer, an experienced technician or
call the Bruno Technical Service Department.
Check swivel seat safety switch.
Check that footrest safety tray is not dragging on
stair nosing or hitting debris on stairs.
Check rail for debris that may bump safety switches
(footrest and carriage panels).
This is correct lift operation.
A safety switch in seat swivel prevents unit from
operating with seat "out of position".
Check batteries in remote call/send unit.
Aim remote at carriage.
Remotes must be reprogrammed.
Verify correct operation of limit switches in carriage
assembly.
Wipe down rail.
Apply a small amount of grease to gear rack
only.
41
TROUBLESHOOTING
©Bruno Independent Living Aids, Inc.
®

Publicidad

loading

Este manual también es adecuado para:

3000-i